traceroute6

Traces the route to a specified IPv6 destination

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

traceroute6 <LINE>

Parameters

traceroute6 <LINE>


traceroute6 <LINE>	Traces the route to a destination IPv6 address or hostname <LINE> – Specify the destination IPv6 address or hostname.

Examples

nx9500-6C88097#traceroute6 2001:10:10:10:10:10:10:2
traceroute to 2001:10:10:10:10:10:10:2 (2001:10:10:10:10:10:10:2) from 2001:10:10:10:10:10:10:1, 30 hops max, 16 byte packets
 1  2001:10:10:10:10:10:10:2 (2001:10:10:10:10:10:10:2)  0.622 ms  0.497 ms  0.531 ms
nx9500-6C8809#