logging

Modifies message logging settings

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

logging monitor {<0-7>|alerts|critical|debugging|emergencies|errors|informational|notifications|warnings}

Parameters

logging monitor {<0-7>|alerts|critical|debugging|emergencies|errors|informational|notifications|warnings}


monitor	Sets the terminal lines logging levels. The logging severity levels can be set from 0 - 7. The system configures default settings, if no logging severity level is specified. <0-7> – Optional. Specify the logging severity level from 0-7. The various levels and their implications are as follows: alerts – Optional. Immediate action needed (severity=1) critical – Optional. Critical conditions (severity=2) debugging – Optional. Debugging messages (severity=7) emergencies – Optional. System is unusable (severity=0) errors – Optional. Error conditions (severity=3) informational – Optional. Informational messages (severity=6) notifications – Optional. Normal but significant conditions (severity=5) warnings – Optional. Warning conditions (severity=4) Note: Before configuring the message logging level, ensure logging module is enabled. To enable message logging, in the device‘s configuration mode, execute the logging > on command. Message logging can also be enabled on a profile. All devices using the profile will have message logging enabled.

Examples

ap510-133B38(config-device-94-9B-2C-13-3B-38)#logging on

ap510-133B38>logging monitor debugging

ap510-133B38>show logging

Logging module: enabled
    Aggregation time: disabled
    Console logging: level warnings
    Monitor logging: disabled
    Buffered logging: level warnings
    Syslog logging: level warnings
        Facility: local7

Log Buffer (103 bytes):


Aug 23 13:01:21 2019: %USER-3-ERR: Unspec[1824]: Unable to send message to subscribe for event rim_up.
ap510-133B38>

Related Commands


no (user executable 'no' commands	Resets terminal lines logging levels in the User Executable context
no (privi executable 'no' commands	Resets terminal lines logging levels in the Privi Executable context