lsp

Enables adding of checksum to LSP (label-switched path) messages forwarded across MiNT links. When enabled, this option helps to verify integrity of LSP messages. LSP messages exchanged over MiNT links are often corrupted. These LSP corruptions cause inaccuracies in the SPF (Shortest Path First) calculation process, leading to access point adoption related issues. Enabling LSP checksum helps troubleshooting adoption-related issues.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

lsp checksum

Parameters

lsp checksum


lsp checksum	Enables adding of checksum to LSP messages forwarded across MiNT links. When enabled, the integrity of LSP messages is verified by matching the LSP message checksum at the MiNT link end nodes. In case of a match the message is uncorrupted. This option is disabled by default.

Examples

nx9500-6C8809(config-mint-policy-global-default)#lsp checksum

nx9500-6C8809(config-mint-policy-global-default)#show context
mint-policy global-default
 lsp checksum
nx9500-6C8809(config-mint-policy-global-default)#

Related Commands


no	Disables adding of checksum to LSP messages forwarded across MiNT links