traceroute

Traces the route to a defined destination

Use ‘--help' or ‘-h' to display a complete list of parameters for the traceroute command

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

traceroute <LINE>

Parameters

traceroute <LINE>


traceroute <LINE>	Traces the route to a destination IP address or hostname <LINE> – Specify the destination IPv4 address or hostname.

Examples

NOC-NX9500#traceroute 10.234.160.11
traceroute to 10.234.160.11 (10.234.160.11), 30 hops max, 46 byte packets
 1  10.234.160.11 (10.234.160.11)  8.115 ms  0.410 ms  0.370 ms
NOC-NX9500#