local-ip-address

Configures the manual session‘s source IP address. If no IP address is specified, the tunnel‘s source IP address is automatically configured based on the tunnel peer IP address. This parameter is applicable when establishing the session and responding to incoming requests.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

local-ip-address <IP>

Parameters

local-ip-address <IP>


local-ip-address <IP>	Configures the manual session‘s source IP <IP> – Specify the IP address in the A.B.C.D format.

Examples

nx9500-6C8809(config-profile default-nx5500-l2tpv3-manual-session-test#local-ip-address 1.2.3.4

nx9500-6C8809(config-profile default-nx5500-l2tpv3-manual-session-test)#show context
 l2tpv3 manual-session test
 local-cookie size 8 200 300  
 local-ip-address 1.2.3.4
nx9500-6C8809(config-profile default-nx5500-l2tpv3-manual-session-test)#

Related Commands


no	Resets the manual session‘s local source IP address. This re-establishes the session.