time-it

Verifies the time taken by a particular command between request and response

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

time-it <COMMAND>

time-it <COMMAND>


time-it <COMMAND>	Verifies the time taken by a particular command to execute and provide a result <COMMAND> – Specify the command.

ap505-13403B#time-it config terminal
Enter configuration commands, one per line.  End with CNTL/Z.
That took 0.00 seconds..
ap505-13403B(config)#