dynamic-chain-selection

interface-config-radio-instance

Enables dynamic chanin selection. When enabled, the radio can dynamically change the number of transmit chains used (uses a single chain/antenna for frames at non-11n transmit rates). This option is enabled by default.

Supported in the following platforms:

Access Points — AP5010, AP310i/e, AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/h, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533

Syntax

dynamic-chain-selection {strict}

Parameters

dynamic-chain-selection {strict}


dynamic-chain-selection {strict}	Enables dynamic chain selection. strict – Optional. Uses strict antenna-mode selection (single antenna for non-11n transmit rates)

Example

nx9500-6C8809(config-profile-510TestProfile-if-radio1)#dynamic-chain-selection

Related Commands


no (radio-interface-config-command)	Uses the configured transmit antenna mode for all clients