power

interface-config-ge-instance

Configures PoE (Power over Ethernet) settings on the selected physical interface. Allows you to monitor port power consumption and configure power usage limits and priorities for each GE port.

Supported in the following platforms:

Access Points — AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/h, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533

Syntax

power {best-effort|limit <0-40>|priority [critical|high|low]}

Parameters

power {best-effort|limit <0-40>|priority [critical|high|low]}


power	Configures power related thresholds for this interface
best-effort	Optional. Enables power when the device is not operating from an 802.3at class 4 power source. Note: POE power best effort configuration not available on AP505 and AP510 model access points.
limit <0-40>	Optional. Configures the PoE power limit from 0 - 40 Watts. The default is 30 Watts.
priority [critical\|high\|low]	Optional. Configures the PoE power priority on this interface. This is the priority assigned to this port versus the power requirements of the other ports available on the controller/access point. critical – Sets PoE priority as critical high – Sets PoE priority as high low – Sets PoE priority as low. This is the default setting.

Example

nx9500-6C8809(config-profile-testAP505-if-ge1)#power limit 30

nx9500-6C8809(config-profile-testAP505-if-ge1)#power priority critical

nx9500-6C8809(config-profile-testAP505-if-ge1)#show context
 interface ge1
  ip dhcp trust
  qos trust dscp
  qos trust 802.1p
  power limit 30
  power priority critical
nx9500-6C8809(config-profile-testAP505-if-ge1)#

Related Commands


no	Removes PoE settings on this interface