ldap-deadperiod

Configures LDAP dead period interval

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

ldap-deadperiod <60-300>

Parameters

ldap-deadperiod <60-300>


ldap-deadperiod <60-300>	Configures an LDAP dead period. When enabled, LDAP service allows the AP or controller to bind with the LDAP server and retrieve user details to match with user-defined role filters. The LDAP deadperiod is the interval between two consecutive attempts to bind with the LDAP server. To enable LDAP service, use the ldap-query command. <60-300> – Specify the interval from 60 - 600 seconds. The default is 120 seconds.

Examples

nx9500-6C8809(config-role-policy-test)#ldap-deadperiod 100

nx9500-6C8809(config-role-policy-test)#show context
role-policy test
 default-role use ip-access-list in test precedence 1
 ldap-deadperiod 100
nx9500-6C8809(config-role-policy-test)#

Related Commands


no (role-policy-config-mode-command)	Removes or resets the LDAP deadperiod interval