telnet

Opens a Telnet session between two network devices

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported on the following devices:

Access Points: AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

telnet <IP/HOSTNAME> {<TCP-PORT>} {<INTF-NAME>}

telnet <IP/HOSTNAME> {<TCP-PORT>} {<INTF-NAME>}


<IP/HOSTNAME>	Configures the destination remote system‘s IP (IPv4 or IPv6) address or hostname. The Telnet session is established between the connecting system and the remote system. <IP/HOSTNAME> – Specify the remote system's IPv4 or IPv6 address or hostname.
<TCP-PORT>	Optional. Specify the Transmission Control Protocol (TCP) port number.
<INTF-NAME>	Optional. Specify the interface name for the link local address.

nx9500-6C8809#telnet 10.234.160.37

Entering character mode
Escape character is '^]'.


AP510 release 7.3.1.0-001D
ap510-133B38 login: