DVMRP Commands

This chapter describes Distance Vector Multicast Routing Protocol (DVMRP) commands and how to configure them on the S- K- and 7100-Series platforms. For information about configuring DVRMP, refer to Multicast Configuration in the S-, K-, and 7100 Series Configuration Guide.

Note

IGMP must be enabled on all VLANs running DVMRP. To do this, use the set igmp enable command as described in set igmp enable. It is also recommended that IGMP querying be enabled on all VLANs running DVMRP. To do this, use the set igmp query-enable command as described in set igmp query-enable.