clear ciscodp

Use this command to clear the Cisco Discovery Protocol back to the default values.

Syntax

clear ciscodp {[status | timer | holdtime | port {status | vvid | trust-ext | cos-ext}]} port-string

status	Clears global CiscoDP enable status to default of auto.
timer	Clears the time between CiscoDP PDU transmissions to default of 60 seconds.
holdtime	Clears the time-to-live for CiscoDP PDU data to default of 180 seconds.
port	Clears the CiscoDP port configuration.
status	Clears the individual port operational status to the default of enabled.
vvid	Clears the individual port voice VLAN for CiscoDP PDU transmission to 0.
trust-ext	Clears the trust mode configuration of the port to trusted.
cos-ext	Clears the CoS priority for untrusted traffic of the port to 0.
`port-string`	Specifies the port(s) on which status will be set. For a detailed description of possible port-string values, refer to the S-, K-, and 7100 Series Configuration Guide.

None.

All command modes.

This example shows how to clear all the Cisco DP parameters back to the default settings:

System(rw)->clear ciscodp

This example shows how to clear the Cisco DP port status on port ge.1.5:

System(rw)->clear ciscodp port status ge.1.5

Published May 2016prev | next