Use this command to set the maximum and minimum ports used for TCP or UDP convergence end points detection.
id | Specifies a CEP configuration group ID. This group must be created and enabled using the set cep detection-id command as described in set cep detection-id. Valid values are 1 - 2147483647. |
porthigh | portlow port | Specifies a maximum or minimum UDP or TCP port for CEP detection.Valid values are 1 - 65535. |
None.
All command modes.
This command applies only to Siemens, H.323, and SIP phone detection. Cisco detection uses CiscoDP as its discovery method.
Once UDP and/or TCP phone detection has been specified using the set cep detection-id protocol command as described in set cep detection-id protocol, the protocols will use this port range for detection matching.
This example shows how to set port 65 as the minimum port to be used for convergence end points detection for CEP group 1:
System(rw)->set cep detection-id 1 portlow 65