set summertime date

Use this command to configure specific dates to start and stop daylight savings time.

Syntax

set summertime date start_month start_date start_year start_hr_min end_month end_date end_year end_hr_min [offset_minutes]

Parameters

`start_month`	Specifies the month of the year to start daylight savings time.
`start_date`	Specifies the day of the month to start daylight savings time.
`start_year`	Specifies the year to start daylight savings time.
`start_hr_min`	Specifies the time of day to start daylight savings time. Format is hh:mm.
`end_month`	Specifies the month of the year to end daylight savings time.
`end_date`	Specifies the day of the month to end daylight savings time.
`end_year`	Specifies the year to end daylight savings time.
`end_hr_min`	Specifies the time of day to end daylight savings time. Format is hh:mm.
`offset_minutes`	(Optional) Specifies the amount of time in minutes to offset daylight savings time from the non-daylight savings time system setting. Valid values are 1–1440.

Defaults

If an offset is not specified, none will be applied.

Mode

All command modes.

Usage

These settings will be non-recurring and will have to be reset annually.

Example

This example shows how to set a daylight savings time start date of March 8, 2009 at 2 a.m. and an ending date of November 1, 2009 at 2 a.m. with an offset time of one hour:

System(rw)->set summertime date March 8 2009 02:00 November 1 2009 02:00 60

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback