set cep detection-id

Use this command to create a new H.323, Siemens, or SIP phone detection configuration group, or enable, disable or remove an existing group.

Syntax

set cep detection-id id {create | delete | disable | enable}

`id`	Specifies a CEP configuration group value. Valid values are 1-2147483647.
create \| delete \| disable \| enable	Creates a new convergence end points detection configuration group, or removes, disables or enables an existing group. A group must first be created then enabled to become operational.

None.

All command modes.

This command applies only to Siemens, H.323, and SIP phone detection. Cisco detection uses CiscoDP as its discovery method.

The S- K- and 7100-Series supports the configuration of up to 16 CEP configuration groups on a device.

This example shows how to create CEP detection group 1:

System(rw)->set cep detection-id 1 create

Published May 2016prev | next