Use this command to enable or disable port mirroring of outbound rate limited frames.
| enable | disable | Enables or disables port mirroring of outbound rate limited frames. Default value: disabled. |
| igmp-mcast enable | disable | Enables or disables the mirroring of IGMP multicast frames. |
None.
All command modes.
Create a port mirror using the set port mirroring create command. See set port mirroring for further information.
The S- and K-Series hardware does not allow for port mirroring of an outbound rate limited frame. By default outbound rate limiting is enabled and port mirroring of an outbound rate limited frame is disabled. Use the set port mirroring orl enable command to enable port mirroring of outbound rate limited frames and disable outbound rate limiting for these frames. Use the set port mirroring orl disable command to disable port mirroring of outbound rate limited frames and enable outbound rate limiting of these frames. This command is applied to all port mirrors.
Use the clear port mirroring orl command to set the port mirroring behavior of outbound rate limited frames to its default behavior: disabled. See clear port mirroring orl (S-, K-Series) for further details.
This example shows how to enable port mirroring of outbound rate limited frames and disable outbound rate limiting for these frames:
System(rw)->set port mirroring orl enable
Print
this page
Email this topic
Feedback
View PDF
Download EPUB