show debugging

Use this command to display the IP debug utility settings.

Syntax

show debugging [ospf | bgp | packet | vrrp]

Parameters

ospf	Specifies that only OSPF debug settings will display.
bgp	Specifies that only BGP debug settings will display (S-Series).
packet	Specifies that only IP packet debug settings will display.
vrrp	Specifies that only VRRP debug settings will display.

Defaults

If no option is displayed, all debug settings are shown.

Mode

Configuration command.

Example

This S-Series example shows how to display the IP debug utility settings (K-Series will not display BGP):

System(rw)->show debugging
OSPF settings
 Version           : OSPFV2
 Vrf               : global
 Adjacency         : no
 Lsa Generation    : no
 Packets           : no
 Retransmission    : no
 Trace Interface   : all vlans
 Trace Packet Type : all packets
Packet filter settings
 Status            : disabled - no filter specified
 Throttle          : 10
 Limit             : 10
 Verbose           : yes
VRRP Trace settings
 Advertisements    : no
 Critical IP       : no
 Trace Interface   : all vlans
 Trace VRID        : all vrids
BGP settings
 Vrf               : global
 dampen            : no
 keepalive         : no
 notification      : no
 open              : no
 route-refresh     : no
 route-add         : no
 route-remove      : no
 route-ineligible  : no
 timers            : no
 update            : no
System(rw)->

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback