show ip protocols

Use this command to display information about RIP and OSPF IP protocols running on the device, or under a topology.

Syntax

show ip protocols [topology <topology-name>] [summary]

Parameters

topology <topology-name> (Optional) Specifies the name of the topology for which to display IP protocols.
summary (Optional) Displays summary protocol information.

Defaults

None.

Mode

All command modes.

Example

This example shows how to display IP protocol information:

System(rw)->show ip protocols
Routing Protocol is RIP
  Triggered Updates always
  Sending Updates every 30 seconds
  Invalid after 180 seconds
  Flush after 120 seconds
  Redistributing:
  Send and Receive version 2 only
                        Offset Offset
  Flag      Interface   In     Out    Key-chain
  -----     ----------  ---    ---    ----------
  Routing For Networks:
  Routing Information Sources:
  Distance: (default is 120)
Routing Protocol is OSPF
  Outgoing update filter list for all interfaces is not set
  Incoming update filter list for all interfaces is not set
  Redistributing:  ospf 1
  Routing Information Sources:
199.113.113.0     0.0.0.255