set bonding enable

Use this command to globally enable VSB.

Syntax

set bonding enable

Parameters

None.

Defaults

Bonding is globally disabled.

Mode

All command modes.

Usage

Before globally enabling VSB on your VSB configured chassis you must:

Configure chassis IDs and the VSB system ID using set bonding chassis
Enable at least one interconnect link between each VSB chassis using set bonding port enable
Optionally, assign a new MAC address using set bonding mac, if a non-default MAC address will be used

VSB is globally disabled by default.

To enable bonding when it is disabled, or disable bonding when it is enabled, you must reset the device after entering this command.

A solid blue system CPU LED signifies a bonded enabled system.

Example

This example shows how to configure VSB on a chassis by: configuring chassis 1 for VSB system 1, enabling VSB on ports 1 and 2, and globally enabling VSB on the chassis.

System(rw)->set bonding chassis 1 system-id 1
System(rw)->set bonding port tg.1.1-2 enable
System(rw)->set bonding enable
System(rw)->

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback