show dot1x

Examples

This example shows how to display 802.1X status:

System(rw)->show dot1x
DOT1X is disabled.
System(rw)->

This example shows how to display authentication diagnostics information for ge.1.1:

System(rw)->show dot1x auth-diag ge.1.1
 Port: 1     Auth-Diag:
 Enter Connecting:                    0
 EAP Logoffs While Connecting:        0
 Enter Authenticating:                0
 Success While Authenticating:        0
 Timeouts While Authenticating:       0
 Fail While Authenticating:           0
 ReAuths While Authenticating:        0
 EAP Starts While Authenticating:     0
 EAP Logoff While Authenticating:     0
 ReAuths While Authenticated:         0
 EAP Starts While Authenticated:      0
 EAP Logoff While Authenticated:      0
 Backend Responses:                   0
 Backend Access Challenges:           0
 Backend Other Requests To Supp:      0
 Backend NonNak Responses From Supp:  0
 Backend Auth Successes:              0
 Backend Auth Fails:                  0

This example shows how to display authentication session statistics for ge.1.1:

System(rw)->show dot1x auth-session-stats ge.1.1
 Port: 1     Auth-Session-Stats:
 Session Octets Rx:        0
 Session Octets Tx:        0
 Session Frames Rx:        0
 Session Frames Tx:        0
 Session Id:               (1, 00-00-00-00-00-00)
 Session Authentic Method: Remote Auth Server
 Session Time:             0 secs
 Session Terminate Cause:  Port Failure
 Session UserName:

This example shows how to display authentication statistics for ge.1.1:

System(rw)->show dot1x auth-stats ge.1.1
 Port: 1     Auth-Stats:
 EAPOL Frames Rx:            0
 EAPOL Frames Tx:            0
 EAPOL Start Frames Rx:      0
 EAPOL Logoff Frames Rx:     0
 EAPOL RespId Frames Rx:     0
 EAPOL Resp Frames Rx:       0
 EAPOL ReqId Frames Tx:      0
 EAPOL Req Frames Tx:        0
 Invalid EAPOL Frames Rx:    0
 EAP Length Error Frames Rx: 0
 Last EAPOL Frame Version:   0
 Last EAPOL Frame Source:    0:0:0:0:0:0