Use this command to display device PoE properties.
None.
None.
All command modes.
The show inlinepower output will display eight powersupply status lines regardless of the number of bays in the PoE power shelf. It a power supply bay does not exist or there is no power supply installed, the status will read “not installed.”
This example shows how to display PoE properties for this chassis.
Print
this page
Email this topic
Feedback
View PDF
Download EPUBSystem(rw)->show inlinepower
Total Power Detected : 2400 Watts
Total Power Available : 2400 Watts (100% of Total Power Detected)
Total Power Assigned : 0 Watts
Power Allocation Mode : auto
Power Trap Status : disabled
Power Redundancy Status : not supported
Power Supply 1 Status : installed and operating
Power Supply 2 Status : not installed
Power Supply 3 Status : not installed
Power Supply 4 Status : installed and operating
Power Supply 5 Status : not installed
Power Supply 6 Status : not installed
Power Supply 7 Status : not installed
Power Supply 8 Status : not installed
Slot Oper Power Power Power Class Power Usage Usage PSE Mgmt
Status Limit Assigned Available Budget Usage Trhld Trap Mode
(W) (W) (W) (W) (W) (%) (%) Status
---- ------ ----- -------- --------- ------ ----- ----- ----- -------- ---------
1 on 1632 0 563 2 0 75 disabled real-time
2 0
3 0
4 0
5 0
6 on 2040 0 704 3 0 75 disabled real-time
7 on 1632 0 563 2 0 75 disabled real-time
8 off 1632 0 564 0 0 75 disabled real-time