initial-contact

Use this command to enable the initial contact feature for the IKE policy.

Syntax

initial-contact
no initial-contact

Parameters

None.

Defaults

None.

Mode

IKE policy configuration.

Usage

If the local host has rebooted, peers may have SAs that are no longer valid. If the initial contact feature is enabled, upon reboot an initial contact message is sent to a peer so that it will delete old SAs.

Use the “no” option for this command to disable the initial contact feature for the IKE policy.

Example

This example shows how to enable the initial contact feature for the winRadius IKE policy:

System(su-config)->crypto ike-policy winRadius
System(su-crypto-policy)->initial-contact
System(su-crypto-policy)->