address-family

Use this command to enter the IPv6 unicast IS-IS address family configuration mode.

Syntax

address-family ipv6 unicast

no address-family ipv6 unicast

Parameters

ipv6	Specifies the IPv6 address family.
unicast	Specifies the unicast address family.

Defaults

None.

Mode

IS-IS router configuration.

Usage

By default, IS-IS configuration applies to both IPv4 and IPv6 routes. Use this command to configure IPv6 specific configuration on the device. IPv6 unicast specific address family configuration currently supports:

Administrative distance using distance (IS-IS)
Redistribution of routes from other protocols into IS-IS using redistribute
Address summarization using summary-address

The “no” form of this command removes any IPv6 unicast address family configuration.

Example

This example shows how to enter IPv6 unicast IS-IS address family configuration mode:

System(rw)->configure
System(rw-config)->router isis
System(rw-config-isis)->address-family ipv6 unicast
System(rw-config-isis-af)->

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback