clear multiauth session

Use this command to clear multiauth sessions for the specified MAC address and port.

Syntax

clear multiauth session mac-address port-string [quarantine-agent | cep | dot1x | mac | pwa | radius-snooping | auto-tracking]

Parameters

`mac-address`	Specifies the MAC address of the session to clear.
`port-string`	Specifies the port of the session to clear.
quarantine-agent	(Optional) Specifies the authentication type quarantine-agent (S-, K-Series).
cep	(Optional) Specifies the authentication type Convergence End Point (CEP) authentication.
dot1x	(Optional) Specifies the authentication type IEEE 802.1X Port-Based Network Access Control.
mac	(Optional) Specifies the authentication type Mac authentication.
pwa	(Optional) Specifies the authentication type Port Web Authentication (PWA).
radius-snooping	(Optional) Specifies the authentication type radius-snooping authentication.
auto-tracking	(Optional) Specifies the authentication type auto-tracking (S-, K-Series).

Defaults

If no authentication agent is specified, all sessions for the specified MAC address and port are cleared. Otherwise, only sessions for the specified authentication agent are cleared.

Mode

All command modes.

Examples

This example shows how to clear the session-timeout values, for an active session, for cep and mac authentication types, to the default value of 300 seconds:

System(rw)->clear multiauth idle-timeout cep
System(rw)->clear multiauth idle-timeout mac

This example shows how to clear the session-timeout values, for an active session, for all authentication types, to the default value of 300 seconds:

System(rw)->clear multiauth idle-timeout

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback