show igmp vlan

Use this command to display IGMP information for a specific VLAN.

Syntax

show igmp vlan [vlan-list]

Parameters

vlan-list

(Optional) Show IGMP info for the specified VLAN only.

Defaults

If a VLAN is not specified, information for all VLANs are displayed.

Mode

All command modes.

Example

This example shows how to display igmp information for VLAN 12:

System(rw)->show igmp vlan 12
--------------------------------------------------------------------------------
IGMP Vlan 12 Info
Querying                    - Enabled
QueryInterval(sec.)         - 125
Status                      - Active
Version                     - 2
QueryMaxResponseTime(sec.)  - 10
Robustness                  - 2
LastMemberQueryIntvl(sec.)  - 1
FastLeaveState              - Disabled
QuerierUpTime               - 0 D  4 H  42 M  18 S
QuerierExpiryTime           - 0 D  0 H  0 M  0 S
QuerierIP                   - 192.168.104.3
Router(s) seen on ports     - none.
Router Ports Egressing      - none.

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback