faildetect reset

Use this command to reset an IPv4 or IPv6 TWCB cache server faildetect configuration to its application default settings.

Syntax

faildetect reset

Parameters

None.

Defaults

None.

Mode

Configuration command, TWCB Cache Server Configuration mode.

Usage

The faildetect reset command in a cache server configuration context does the following:

Sets the faildetect type to the default value of probe
Sets the probe for faildetect probe one to $twcb_default
Removes any configured probe for faildetect probe two

Example

This example shows how to reset all faildetect configuration to the factory default settings for the 101.10.1.251 cache server on server farm s1Server and 2001:abcd::5 cache server on the server farm s2Server:

System(su-config)->ip slb serverfarm s1Server
System(su-config-twcb-wcsfarm)->cache 101.10.1.251
System(su-config-twcb-cache)->faildetect reset
System(su-config-twcb-cache)->inservice
System(su-config-twcb-cache)->exit
System(su-config-twcb-wcsfarm)->exit
System(su-config)->ip slb serverfarm s2Server
System(su-config-twcb-wcsfarm)->cache 2001:abcd::5
System(su-config-twcb-cache)->faildetect reset
System(su-config-twcb-cache)->inservice
System(su-config-twcb-cache)->

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback