show nodealias config

Example

This example shows how to display node alias configuration settings for port ge.1.1:

System(rw)->show nodealias config ge.1.1
Max Control Entries     = 44                  Active Entries = 44
Purge Time              = 01:16:09       State          = ready(2)
Port Number        Max Entries         Used Entries         Status
-----------        -----------         ------------         ----------
ge.1.1             44                  44                   Enabled

show nodealias config Output Details provides an explanation of the command output.

show nodealias config Output Details

Output...	What it displays...
Max Control Entries	Specifies the number of entries used across all ports.
Active Entries	Specifies the number of active entries across all ports.
Port Number	Port designation.
Max Entries	Maximum number of alias entries configured for this port. Set using set nodealias maxentries.
Used Entries	Number of alias entries (out of the maximum amount configured) already used by this port.
Status	Whether or not a node alias agent is enabled (default) or disabled on this port.