clear physical alias

Use this command to reset the alias for a physical object to a zero-length string.

Syntax

S- and K-Series

clear physical alias {[chassis chassis] [slot slot] [backplane backplane] [module module] sub-module slot module | [powersupply powersupply] [powersupply-slot powersupply-slot] [fan] [fan-slot] [port port-string]}

7100-Series

clear physical alias {[chassis chassis] [module module] | [powersupply powersupply] [powersupply-slot powersupply-slot] [fan] [fan-slot] [port port-string]}

Parameters

chassis `chassis`	Clears the chassis alias.
slot `slot`	Clears and alias for a specific slot (S-, K-Series).
backplane `backplane`	Clears and alias for a specific backplane. Valid values are 1 for FTM 1 and 2 for FTM 2 (S-, K-Series).
module `module`	Clears an alias for a specific module.
powersupply `powersupply`	Clears an alias for a specific power supply. Valid values are 1 or 2.
sub-module `slot` `module`	Specifies the sub-module installed in its parent module expansion slot for which to clear an alias. slot specifies the chassis slot the parent module is installed in. module specifies the sub-module ID (S-, K-Series).
fan	Clears the fan tray alias
port `port-string`	Clears an alias for a specific port. For a detailed description of possible port-string values, refer to Port String Syntax Used in the CLI in the S-, K-, and 7100 Series Configuration Guide.

Defaults

None.

Mode

All command modes.

Usage

The slot, backplane, and submodule options are supported on the S- and K-Series platforms.

Example

This example shows how to set clear the alias set for the chassis:

System(rw)->clear physical alias chassis
System(rw)->

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback