Use this command to identify a RIP authentication key on a key chain.
| key-id | Specifies an authentication number for a key. Valid number are from 1 to 255. Only one key is supported per key chain in this S- K- and 7100-Series release. |
None.
Configuration command, key chain configuration.
This release of the S- K- and 7100-Series firmware supports only one key per key chain.
This command places you in key configuration command mode.
The “no” form of this command removes the key from the key chain.
This example shows how to create authentication key 3 within the key chain called “md5key”:
System(rw-config)->key chain md5key System(rw-config-keychain)->key 3
Print
this page
Email this topic
Feedback
View PDF
Download EPUB