set spantree porthello

Use this command to set the hello time for one or more Spanning Tree ports. This is the time interval (in seconds) the port(s) will transmit BPDUs.

Syntax

set spantree porthello port-string interval

Parameters

port-string Specifies the port(s) for which to set hello time.
interval Specifies the number of seconds the system waits before broadcasting a bridge hello message. Valid values are 1 - 10.

Defaults

None.

Mode

All command modes.

Usage

This command can be executed only if bridge hello mode is disabled. For information on using the set spantree bridgehellomode command, refer to set spantree bridgehellomode.

Example

This example shows how to set the hello time to 3 seconds for port ge.1.4:

System(rw)->set spantree porthello ge.1.4 3