show netflow

Use this command to display NetFlow configuration information and statistics.

Syntax

show netflow [config [port-string]] [statistics [export]]

Parameters

config	(Optional) Show the NetFlow configuration.
statistics	(Optional) Show the NetFlow statistics.
export	(Optional) Show the NetFlow export statistics.
`port-string`	(Optional) Specifies the port or ports to display.

Defaults

If config is entered, but no port-string, information for all ports is displayed.
If statistics is entered but not export, all statistics are displayed.
If no options are entered, all NetFlow configuration and statistics information is displayed

Mode

All command modes, Read Only.

Example

This example shows how to display both NetFlow configuration information and statistics:

System(rw)->show netflow
Cache Status:           enabled
Export Version:               9
Export Interval:             30 (min)
Number of Entries:       1048575
Inactive Timer:              40 (sec)
Template Refresh-rate:       20 (packets)
Template Timeout:            30 (min)
Enabled Optional Export Data:
-----------------------------
None
Destination IP                          UDP Port
--------------------------------------- --------
10.10.1.1                               2055
10.10.1.2                               2055
10.10.1.3                               2055
10.10.1.4                               2055
Enabled Ports Both Ingress and Egress:
-------------------------------------
ge.1.1-5
Disabled Ports:
-----------------
lag.0.1-62
ge.1.6-48
tg.1.1-4
Export Statistics:
------------------------------------
Network Packets Sampled:          10
Exported Packets:                  0
Exported Records:                  0
Export Packets Failed:             0
Export Records Dropped:            0

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback