Use this command to configure a phantom configuration for the specified chassis slot.
| slot-num | Specify the chassis slot number to configure a phantom configuration for. |
| model | Specify the model of the linecard that will eventually reside in the specified chassis slot number. |
None.
All command modes.
Phantom configuration allows for the configuration of a chassis slot for a specified module prior to inserting the module. Once the specified module type is inserted into the slot, any phantom configuration that exists is pushed on to the inserted module. If the module inserted does not agree with the module specified in this command, the phantom configuration is not pushed on to the inserted module.
The following command allows you to enter a phantom configuration for slot 3 module model KT2006-0224:
System(rw)-> set linecard 3 KT2006-0224
Print
this page
Email this topic
Feedback
View PDF
Download EPUB