set physical assetid

Use this command to set the asset ID for a module.

Syntax

S- and K-Series

set physical assetid {chassis chassis | module module | sub-module slot module | powersupply powersupply | poe-powersupply poe-powersupply | fan fan} string

7100-Series

set physical assetid {chassis chassis | module module | powersupply powersupply | fan fan} string

Parameters

chassis `chassis`	Sets an asset ID for this chassis.
module `module`	Sets an asset ID for a specific module.
sub-module `slot` `module`	Sets an asset ID for the sub-module installed in its parent module expansion slot. slot specifies the chassis slot the parent module is installed in. module specifies the sub-module ID (S-, K-Series).
powersupply `powersupply`	Sets an asset ID for the specified power supply.
poe-powersupply `poe-powersupply`	Sets an asset ID for the specified POE power supply (S-, K-Series).
fan `fan`	Sets an asset ID for the specified fan.
`string`	Specifies the asset ID.

Defaults

None.

Mode

All command modes.

Usage

The sub-module and poe-powersupply options are supported on the S- and K-Series platforms.

Example

This example shows how to set the asset ID information for module 1 to “mod1”:

System(rw)->set physical assetid module 1 mod1
System(rw)->

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback