Use this command to enable or disable LACP flow regeneration.
| enable | disable | Enables or disables LACP flow regeneration |
Disabled.
All command modes.
When enabled and a new port joins a link aggregation group (LAG), LACP will redistribute all existing flows over the LAG. It will also attempt to load balance existing flows to take advantage of ports added to the LAG. When flow regeneration is disabled and a new port joins a LAG, LACP will only distribute new flows over the increased number of ports in the LAG and will leave existing flows intact.
This example shows how to enable LACP flow regeneration:
System(rw)->set lacp flowRegeneration enable
Print
this page
Email this topic
Feedback
View PDF
Download EPUB