show interface

Use this command to display information about one or more interfaces (VLANs or loopbacks) configured on the router.

Syntax

show interface [interface-name]

Parameters

interface-name (Optional) Specifies the name of an interface, such as vlan.0.1.

Defaults

If an interface-name not specified, information for all routing interfaces will be displayed.

Mode

All command modes.

Example

This example shows how to display information for all interfaces configured on the router.

System(rw)->show interface
 vlan.0.1 is Administratively up, Operationally up
   IP Address 10.21.130.59 Mask 255.255.128.0
   MAC-Address is: 0011.880c.9f78
   The name of this device is vlan.0.1
   MTU is 1500 bytes
   The bandwidth is 10000 Mb/s
   Encapsulation ARPA, Loopback not set
   ARP type: ARPA,   ARP Timeout: 3600 seconds
   Policy Routing disabled
 vlan.0.5 is Administratively down, Operationally down
   MAC-Address is: 0011.880c.9f78
   The name of this device is vlan.0.5
   MTU is 1500 bytes
   The bandwidth is 10000 Mb/s
   Encapsulation ARPA, Loopback not set
   ARP type: ARPA,   ARP Timeout: 3600 seconds
   Policy Routing disabled