show mld vlan

Use this command to show MLD information for the specified VLAN(s).

Syntax

show mld vlan [vlan-list]

Parameters

vlan-list

(Optional) VLAN ID or range of IDs. Valid values are 1 – 4094.

Defaults

If vlan-list is not displayed, information for all VLANs are displayed.

Mode

All command modes.

Example

This example displays the MLD information for VLAN 2501:

System(rw)->show mld vlan 2501
--------------------------------------------------------------------------------
MLD Vlan 2501 Info
Querying                    - Enabled
QueryInterval(sec.)         - 125
Status                      - Active
Version                     - 2
QueryMaxResponseTime(sec.)  - 10
Robustness                  - 2
LastMemberQueryIntvl        - 10
FastLeaveState              - Disabled
QuerierUpTime               - 1 D  1 H  17 M  19 S
QuerierExpiryTime           - 0 D  0 H  0 M  0 S
QuerierIP                   - fe80::21f:45ff:fe5b:f5cf
Router(s) seen on ports     - none.
Router Ports Egressing      - none.

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback