show cfm all

Use this command to display CFM status and configuration for all CFM MDs, associations, and end-points.

Syntax

show cfm all

Parameters

None.

Defaults

None.

Mode

All command modes.

Examples

This example shows how to display CFM configuration and status for all MDs, associations, and end-points:

System(rw)->show cfm all
CFM global status is enabled
System Default MD values
  MD Level         : 0
  MHF Creation     : None
  MHF ID-permission: None
================================================================================
        MD               MD Name    MD      MHF     MHF       Next            MD
     Index             Name Type Level   Create    Perm   MA Index        Status
---------- ---------------- ---- ----- -------- ------- ---------- -------------
         2                  None     4     None    None          2        Active
--------------------------------------------------------------------------------
        MA                                     MA    Name      CCM            MA
     Index                                   Name    Type Interval        Status
---------- -------------------------------------- ------- -------- -------------
         1                                   2000 Integer     1sec        Active
    Bridge                      MHF                 MHF       MA Comp
    CompId        Selector   Create       ID-permission        Status
---------- --------------- -------- ------------------- -------------
         1        VID 2000    Defer       SendIdChassis        Active
      MEP-List
        Status
--------------
        Active : 1600-1601,1605-1610,1615-1624,8191
 MEP           Active        MEP  MEP    CCI               MAC           MEP
  ID         Selector       Port  Dir Enable              Addr        Status
---- ---------------- ---------- ---- ------ ----------------- -------------
1601         VID 2000    ge.2.15   Up   True 00-1f-45-9f-40-46        ActiveSystem(rw)->