show ciscodp

Example

This example shows how to display Cisco Discovery Protocol information. In this case, defaults have not been changed:

System(rw)->show ciscodp
CiscoDP : Auto
Timer : 60
Holdtime (TTL) : 180
Device ID : 00E06314BD57
Last Change : WED FEB 08 01:07:45 2006

show ciscodp Output Details provides an explanation of the command output.

show ciscodp Output Details

Output...	What it displays...
CiscoDP	Whether Cisco Discovery Protocol is disabled or enabled globally. Auto indicates that Cisco DP will be globally enabled only if Cisco DP PDUs are received. Default setting of auto can be changed with the set ciscodp status command as described in set ciscodp status.
Timer	Number of seconds between Cisco Discovery Protocol PDU transmissions. Default value of 60 can be changed with the set ciscodp timer command as described in set ciscodp timer.
Holdtime (TTL)	Number of seconds neighboring devices will hold PDU transmissions from the sending device. Default value of 180 can be changed with the set ciscodp holdtime command as described in set ciscodp holdtime.
Device ID	The MAC address of the switch.
Last Change	The time that the last Cisco DP neighbor was discovered.