show nodealias protocol

Use this command to display node alias entries based on protocol and protocol address.

Syntax

show nodealias protocol {protocol} [ip_address ip-address] [port-string]

Parameters

`protocol`	Specifies the protocol for which to display node alias entries. Refer to Supported Node Alias Entry Protocols for a list and description of supported protocols.
ip-address `ip-address`	(Optional) Used for IP protocol only, displays node alias entries for a specific source address.
port-string	(Optional) Displays node alias entries for specific port(s).

Defaults

If ip_address ip-address is not specified for the IP protocol, IP-related entries will be displayed from all source addresses.
If port-string is not specified, node alias entries will be displayed for all ports.

Mode

All command modes.

Example

This example shows how to display node alias entries for IP traffic on ge.1.13. Refer back to show nodealias Output Details for a description of the command output.

System(rw)->show nodealias protocol ip ge.1.13
Port: ge.1.13   Time: 20 days 01 hrs 23 mins 47 secs
--------------------------------------------------------
Alias ID         = 84              Active           = true
Vlan ID          = 113             MAC Address      = 00-01-f4-5b-60-20
Protocol         = ip              Source IP        = 0.0.0.0
Port: ge.1.13   Time: 2 days 21 hrs 52 mins 28 secs
--------------------------------------------------------
Alias ID         = 39              Active           = true
Vlan ID          = 113             MAC Address      = 00-01-f4-5b-60-20
Protocol         = ip              Source IP        = 10.1.128.1

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback