Use this command to set a non-broadcast neighbor polling interval.
| seconds | Specifies the number of seconds between polls for this non-broadcast neighbor. Valid values: 0 - 4294967295. Default: 120 seconds. |
None.
Interface configuration.
The polling interval sets the time between hello messages sent to this interface‘s neighbor.
The “no” form of this command resets the value to the default of 120.
This example shows how to set the OSPFv3 neighbor polling interval on VLAN 1:
System(rw-config)->interface vlan 1 System(rw-config-intf-vlan.0.1)->ipv6 ospf poll-interval 150
Print
this page
Email this topic
Feedback
View PDF
Download EPUB