Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

set inlinepower management

Use this command to set the PoE management mode on a specified module.

Syntax

set inlinepower management {realtime | class} module-number

Parameters

realtime Manages power based on the actual power consumption of the ports.
class Manages power based on the IEEE 802.3af definition of the class upper limit.
module-number Specifies the module on which to set the PoE management mode. If you are configuring this value on an S-Series SSA, use 1 as the module number.

Defaults

None.

Mode

All command modes.

Example

This example shows how to set the PoE management mode to “class” on module 1:

System(rw)->set inlinepower management class 1
Published May 2016prev | next

Email this topicEmail this topic

Print this pagePrint this page