Use this command to configure the retransmit interval for an OSPF sham link.
| area-id | Specifies the OSPF area the two PE routers belong to. |
| source-ip-address | Specifies the source IP address for this sham link. |
| destination-ip-address | Specifies the destination IP address for this sham link. |
| seconds | (Optional) Specifies the number of seconds between successive retransmissions of the same LSAs. Valid values are greater than the expected amount of time required for the update packet to reach and return from the interface, and range from 1 to 3600. The default value is 5 seconds. |
Retransmit interval defaults to 5 seconds.
VRF configuration, OSPF router configuration.
The “no” form of this command resets the sham link retransmit interval value to the default value.
This example shows how to configure the retransmit interval to 10 for a sham link between two PE routers with a source address of 172.16.1.10 and a destination address of 172.16.2.20 on OSPF router instance 10, VRF doc:
System(su)->router doc System(su-doc)->configure System(su-doc-config)->router ospf 10 System(su-doc-config-ospf-10)->enable-pe-ce System(su-doc-config-ospf-10)->area 10 sham-link 172.16.1.10 172.16.2.20
Print
this page
Email this topic
Feedback
View PDF
Download EPUB