Use this command to set the managed address configuration flag in router advertisements.
None.
None.
Interface configuration.
When the managed address configuration flag is set, attached hosts use stateful autoconfiguration to obtain addresses. The managed address configuration flag feature is disabled by default.
The no ipv6 nd managed-config-flag command disables the use of stateful autoconfiguration by attached hosts to obtain addresses.
This example enables the use of stateful autoconfiguration by attached hosts to obtain addresses on VLAN 50:
System(su-config)->interface vlan 50 System(su-config-intf-vlan.0.50)->ipv6 nd managed-config-flag System(su-config-intf-vlan.0.50)->