clear cos port-resource flood-ctrl

Use this command to clear one or all Class of Service flood control port resource configurations.

Syntax

clear cos port-resource flood-ctrl all | group-type-index resource [unit] [rate] [type] [syslog] [trap] [disable-port] [violators port-list]

all \| `group-type-index`	Clears all outbound rate limiting port resource entries or a specific entry. Valid entries are in the form of group.type. Group can be 0 - 11, with 0 designating the default group, and 1 - 11 reserved for user-defined groups. Port type can be 0 - 1 for the S- and K-Series and 0 for the 7100-Series.
`resource`	Specifies a resource entry to be cleared.
unit	(Optional) Clears the unit of measure setting.
rate	(Optional) Clears the data rate setting.
type	(Optional) Clears the type of action setting.
syslog	(Optional) Clears the Syslog setting (S-, K-Series).
trap	(Optional) Clears the SNMP trap setting (S-, K-Series).
disable-port	(Optional) Clears the disable port setting (S-, K-Series).
violators `port-list`	(Optional) Clears the limit violation setting (S-, K-Series).

If no options are specified, all non-default settings will be cleared for the associated flood control settings.

All command modes.

This S- and K-Series example shows how to clear all flood control settings associated with port group 0.1 and resource entry 0:

System(rw)->clear cos port-resource flood-ctrl 0.1 0

This 7100-Series example shows how to clear all flood control settings associated with port group 0.0 and resource entry 0:

System(rw)->clear cos port-resource flood-ctrl 0.0 0

Published May 2016prev | next