show ipv6 twcb webcaches

Use this command to display information associated with the specified or all IPv6 web caches.

Syntax

show ipv6 twcb webcaches [webcache-name | detail]

Parameters

`webcache-name`	(Optional) Specifies the name of the web cache for the display of information.
detail	(Optional) Specifies that a detailed level of information should display.

Defaults

If no parameter is specified, detailed information for all web caches is displayed.

Mode

All command modes.

Example

This example displays detailed information about all configured web caches.:

System(rw)->show ipv6 twcb webcaches detail
WebCache: v6_cache (DOWN) (IPv6)
   Current Conns:                      0 Hits:                            0
   Idle Timeout:                     240 State Changes:                   0
   Http-Port:                         80
   Source NAT Pool:              Not Set
   Destination IP:               Not Set
   Last state change:             TUE JUL 17 12:53:22 2012
   Last state change reason:      SERVERFARM changed state
   Serverfarms(1):
     v6_farm
   Bypass List Acl:              Not Set
   Host Acl:                     Not Set
Webcaches in active state: 0
System(rw)->

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback