Use this command to enable or disable the sending of an SNMP trap message for a module whenever the status of its ports changes, or whenever the module‘s PoE usage threshold is crossed.
| disable | enable | Disables or enables PoE trap messaging. |
| module-number | Specifies the module on which to disable or enable trap messaging. If you are configuring this value on an S-Series, use 1 as the module number. |
Disabled.
All command modes.
The module‘s PoE usage threshold must be set using the set inlinepower threshold command as described in set inlinepower threshold.
This example shows how to enable PoE trap messaging on module 1:
System(rw)->set inlinepower psetrap enable 1
Print
this page
Email this topic
Feedback
View PDF
Download EPUB