show policy autoclear (S-, K-Series)

Use this command to display the status of the policy auto clear function.

Syntax

show policy autoclear {all | link | interval | profile | ports}

Parameters

all	Displays all auto clear status information.
link	Displays rule usage when a link‘s operating status of up is detected.
interval	Displays the interval in minutes at which the device will automatically clear rule usage statistics.
profile	Displays profiles for which rule usage has been cleared when an assigned profile has been activated.
ports	Displays port(s) on which rule usage statistics will be automatically cleared by one of the auto clear actions (link/interval/profile).

Defaults

None.

Mode

All command modes.

Example

This example shows how to display all auto clear status information. In this case, the auto clear function has not been configured:

System(rw)->show policy autoclear all
AutoClear interval is 0 minute(s)
AutoClear on link status is DISABLED
AutoClear on profile status is DISABLED
AutoClear port-list: none

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback