set cep port

Use this command to enable or disable a CEP detection type on one or more ports.

Syntax

set cep port port-string {cisco | h323 | lldp-med | siemens | sip} {enable | disable}

Parameters

port-string Specifies the port(s) to enable or disable. For a detailed description of possible port-string values, refer to the S-, K-, and 7100 Series Configuration Guide.
cisco Set the Cisco detection status on the specified ports.
h323 Set the H323 detection status on the specified ports.
lldp-med Set the LLDP-MED detection status on the specified ports.
siemens Set the Siemens detection status on the specified ports.
sip Set the SIP detection status on the specified ports.
enable | disable Enables or disables CEP detection as specified.

Defaults

None.

Mode

All command modes.

Example

This example shows how to enable Cisco phone detection on port ge. 3. 1:

System(rw)->set cep port ge.3.1 cisco enable