Use this command to assign the tunnel to a Split Horizon group.
group-id | Specifies the Split Horizon group the tunnel is assigned to. Valid values are 1 - 62 (S-Series) and 1 - 16 (K-Series). |
None.
Tunnel Interface Configuration command mode.
.
Use the “no” option for this command to remove the tunnel from the Split Horizon group.
This example shows how to set the Split Horizon group to 1 for tunnel 1:
System(rw)->configure System(rw-config)->interface tunnel 1 System(rw-config-intf-tun.0.1)->tunnel split-horizon-group 1 System(rw-config-intf-tun.0.1)->