set spantree mstcfgid

Use this command to set the MST configuration name and/or revision level.

Syntax

set spantree mstcfgid {[cfgname name] [rev level]}

Parameters

cfgname `name`	Specifies an MST configuration name. The MST configuration name defaults to the device MAC address.
rev `level`	Specifies an MST revision level. Valid values are 0 - 65535.

Defaults

If the MST configuration name is not specified, an MST configuration name defaults to the bridge MAC address.

If the MST revision level is not specified, an MST revision level defaults to 0.

Mode

All command modes.

Usage

This command allows you to configure either the MST region name or revision level or both. Any device that wishes to belong to the same MST region as another device must be administratively configured with the same region name and revision level. The MST region name defaults to the bridge MAC address. The MST revision level is an arbitrary administratively defined value that defaults to 0.

Example

This example shows how to set the MST configuration name to “mstconfig”:

System(rw)->set spantree mstcfgid cfgname mstconfig

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback